Edit

Trim a video

Give a start and an end in seconds and get just that section back — without uploading the file.

Drop a video here, or click to choose

Output MP4 · nothing leaves this tab

Your file never leaves this tab. The first run downloads the engine once — about 10 MB over the wire — then the browser caches it.

Trimming is the highest-value edit you can make before compressing. A two-minute clip cut to forty seconds gives the encoder three times the bitrate for every remaining frame, which improves the picture far more than any quality setting. Cut first, compress second.

Enter a start time in seconds and, optionally, an end time. Leave the end blank to keep everything from the start to the finish. Fractions work — 12.5 is twelve and a half seconds. The tool seeks to the start before decoding, so long files do not have to be read from the beginning.

This re-encodes the section rather than copying it, because a stream copy can only cut on keyframes and would give you a start point up to several seconds off. Re-encoding at CRF 20 makes the cut frame-accurate and visually indistinguishable from the source, at the cost of a little time.

Output is H.264 MP4 with AAC audio. Nothing is uploaded, so a private recording stays private. Once you have the trimmed file, compress it with any target size or convert it to GIF — the tools are linked below.

Questions

Is the cut frame-accurate?

Yes — it re-encodes from the exact timestamp rather than snapping to the nearest keyframe.

What if I leave the end blank?

Everything from the start time to the end of the clip is kept.

Can I cut out a middle section?

A trim keeps one continuous section. To remove a middle part you would trim twice and join the pieces in an editor.

Does trimming lose quality?

A little, because it re-encodes at CRF 20. That is visually near-lossless, and far more accurate than a stream copy.